Smart Momma has been
wanting to make my own pillow case now and since I don’t own a sewing machine
(it’s not that I don’t want to, it’s just that I am saving money to get a good
one for good), an iron-on adhesive will work for now.
And so the project began…
Went to Jo-Anns and
purchased two rolls of this iron-on adhesive.
Used a flat sheet to
make this pillow case, I like the pattern of the fabric. I chose light-colored because I am going to
put it in my dark-red living room set.
It looks so busy and
dark that all it needs is a calm, light and airy color.
And I am in the
process of making this happen – or else, this living room set will go to
somebody else’s living room or to Goodwill.
So anyway, going back
to the no-sew pillow case.
Just cut the desired
size – like what I did, I just placed the pillow on top of the fabric and put 1&½
inches allowance on three sides and 5 inches allowance on one side.
Yes- 5 inches on one
side, you will find out why later on….
Place the fabric on
the iron board face up then the other side of the fabric face down, then
separate them like in my picture below.
Pre-heat your iron to
medium setting, while you tape the iron-on adhesive with the paper side on top
all the way to the end on the fabric that’s facing up on the iron board. I used a laundry clip to hold my iron-on
tape.
Then I started
pressing the iron-on tape to the fabric all the way through.
Let it cool it down, then
remove the paper of the iron-on tape.
Then carefully place
the fabric that’s facing down on top of the adhesive, making sure that the
fabrics are lined up.
Then iron the fabric,
5-6 seconds at a time, until all has been pressed. Flip the fabric on the other side and do the
same thing, iron it for 5-6 seconds.
Repeat this process
to all of the three sides that has 1&½ allowance. Leaving that one side with 5 inches allowance
open.
When done with the
three sides, wait for it to cool down (10-15 minutes maybe)
Reverse the pillow
case inside out.
Iron the three sides
again, to have a more polished and clean look, and the entire pillow case.
Wait for it to cool
down or for the adhesive to adhere. (30
minutes maybe)
Then put your pillow
inside your new pillow case on the 5 inches allowance opening.
And then fold the 5
inches extra fabric inside the case, like the picture below.
Smoothen the fabric and voila! Here’s my
no-sew pillow case!
Not just one but four! :)
I am surprisingly pleased with the result....I thought the tape will not hold the fabric enough and will show some opened up areas. But nope! It looks clean and polished.
I am so happy!! What do you think?
huggies***
smartmomma
![]()